Stryker MV3 Bariatric Bed Mode D'emploi page 27

• Always make sure that cables, wires, and tubing from other equipment are routed so that they are not pinched by parts
of the product.
N N o o t t e e - - Do not use siderails as a patient restraint device.
To lower the siderail to the intermediate position, press the release button and rotate the siderail forward until it stops at the
intermediate position (Figure 16).
To lower the siderail to its lowest position, press and hold the release button and rotate the siderail to the lowest position
(Figure 17).
F F i i g g u u r r e e 1 1 7 7 – – S S i i d d e e r r a a i i l l l l o o w w e e s s t t p p o o s s i i t t i i o o n n
N N o o t t e e
• You can stow the siderail under the litter when the siderail is at the lowest position.
• You cannot place the product in the lowest position with the siderails stowed.
S S e e c c u u r r i i n n g g p p a a t t i i e e n n t t r r e e s s t t r r a a i i n n t t s s t t r r a a p p s s
There are ten patient restraint strap tie-in locations on the litter assembly to secure patient restraint straps. Two are located
on the Fowler section, four are located on the knee Gatch section, and four are located on the foot section (Figure 18).
N N o o t t e e - - The two slots located on the Fowler surface and the two slots located on the foot surface are mattress tie-in
locations only.
5900-009-001 Rev F.1 23 EN