Screwing On The Wall Mounting Bracket; Attaching The Charger Cable; Inserting / Removing The Main Unit; Fitting The Nozzle Holder - Cleanmaxx FOL- 818 Mode D'emploi

Screwing On the Wall Mounting
Bracket
1. Place the wall mounting bracket ver-
tically against the wall with the cable
holder pointing downwards, and mark
out two drill holes.
2. Drill holes into the wall and place
anchors in them.
3. Screw on the wall mounting bracket.

Attaching the Charger Cable

1. Twist the cable holder a little anti-
clockwise until it is released (Picture E
I), and detach it from the wall mount-
ing bracket (Picture E II).
2. Plug the barrel connector of the
charger cable into the cable holder
and clip the cable into the slot of the
cable holder.
3. Reinsert the cable holder into the
wall mounting bracket and twist it to
secure it (Picture E III).

Inserting / Removing the Main Unit

• Inserting: Insert the main unit (17)
from above into the wall mounting
bracket so that the barrel connector of
the charger cable is plugged into the
charging socket (34). Then press the
main unit gently towards the wall until
it engages in the retaining bracket.
• Removing: Pull the main unit gently
away from the wall and pull it up and
out.
FITTING THE NOZZLE
HOLDER
The nozzle holder (6) is attached to the
suction tube and fixed in place with a
screw. Two nozzles can be plugged into
the nozzle holder for storage (Picture A).
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 21 04350_Inlay_de-en-fr-nl_A5_V1_1.indb 21
CHARGING UP THE
BATTERY
Please Note!
■
Only connect the charger cable to a
plug socket that is properly installed
and matches its technical data. The
plug socket must be readily accessible
after connection so that the con-
nection to the mains can quickly be
isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the charger cable.
■
Remove the charger cable from the
plug socket if a fault occurs during
charging or if a thunderstorm is ex-
pected.
■
Only ever charge up the battery
with the charger cable supplied with
it (GQ18-270065). Do not use this
charger cable to charge up any other
devices.
■
Unwind the charger cable fully before
connecting it.
■
It is essential that you charge up the
battery fully before you first use the
device in order to achieve the maxi-
mum charging capacity. If the battery
is fully discharged during use, it must
be fully charged up again before it is
next used.
The operating lamps (48) of the main
unit (10) indicate the battery charge
status. If all three are lit up, the bat-
tery (1) is full. If only one operating lamp
is flashing, the battery is weak and needs
to be charged.
Switch off the device for charging.
• Without wall mounting bracket:
Connect the charger cable (13) to
the charging socket (34) and a plug
socket. Disconnect it from the mains
power after charging.
EN
21
07.05.2020 15:50:45 07.05.2020 15:50:45