Fresh Water Tank; Dirty Water Tank; Accessories Of The Wet Cleaning Nozzle; Storage - Cleanmaxx FOL- 818 Mode D'emploi

EN

Fresh Water Tank

1. Take the fresh water tank (12) out of
the wet cleaning nozzle (8), take off
the lid (18) and fully empty the fresh
water tank.
2. Allow the fresh water tank to dry in
the air.

Dirty Water Tank

1. Take the top and bottom dirty water
tank (15, 14) off the main unit (17)
and the wet cleaning nozzle (8) (see
the "Use as a Wet Cleaner" chapter –
"Taking Apart").
2. Twist the lid (41) a little and take it off.
3. Empty the dirty water tank.
4. For cleaning, take apart the two dirty
water tanks and rinse them out thor-
oughly with clear water.
5. Allow all parts to dry in the air.
Accessories of the Wet Cleaning
Nozzle
• Take the mop roller (10) and suction
nozzle (11) off the wet cleaning noz-
zle (8) (see the "Use as a Wet Clean-
er" chapter – "Wet Cleaning Nozzle")
and rinse under running water. Allow
them to dry in the air.
• Detach the cleaning cloth (24) and
rinse by hand. Do not use any fabric
softener and do not iron. Allow it to
dry in the air. Follow the instructions
on the washing label.
26
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 26 04350_Inlay_de-en-fr-nl_A5_V1_1.indb 26

STORAGE

• Store the device in the wall mounting
bracket (16).
• If the device is not going to be used
for a prolonged period, pull the
charger cable out of the plug sock-
et and remove the battery (see the
"Charging Up the Battery" chapter).
Store all accessories in a cool, dry
place which is protected from direct
sunlight and is out of the reach of
children and animals.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec­
trical device yourself!
The device does not start.
The battery is empty.
►
Charge up the battery.
The performance is too weak.
The battery is weak.
►
Charge up the battery.
The dust container is too full.
►
Empty the dust container.
The filters are dirty.
►
Clean the filters.
The suction opening is blocked.
►
Switch off the device and remove the
blockage.
The dirt particles are too large or too
heavy.
►
Switch off the device and remove dirt
particles by hand.
07.05.2020 15:50:45 07.05.2020 15:50:45