Fitting The Wall Mounting Bracket; Use - Cleanmaxx SLX225C Mode D'emploi

Fitting the Wall Mounting Bracket

ATTENTION!
■ Choose a suitable place for the wall mounting bracket which should be as dry and
close to a plug socket as possible.
■ The wall must be able to hold the weight of the cordless vacuum cleaner.
■ Make sure that you do not drill into or destroy any pipes or cables. Find out
where possible pipes or cables may run and avoid them.
1. Now hold the wall mounting bracket against the chosen location and mark the drill
holes using a pencil.
2. Then attach the wall mounting bracket to the wall using the associated screws and
dowels.
3. If the barrel connector is not already attached in the wall mounting bracket, plug it into
the holder which is provided for this purpose.

Use

ATTENTION!
■ Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■ Make sure that the MAX marking on the collecting container is not exceeded when
liquids are sucked up.
■ Always hold the device horizontally when liquids are sucked up. Make sure that
sucked-up liquids do not get into the motor unit.
■ Empty and clean the collecting container after each use (see the "Cleaning and
Storage" chapter).
■ Do not use the device when it is connected to the mains adapter.
1. Disconnect the mains adapter from the device.
2. Insert one of the attachments into the suction opening on the front of the collecting
container.
3. Select an attachment. The attachments are inserted into the suction opening on the
front of the device:
Crevice nozzle:
Use the crevice nozzle to vacuum in folds in fabrics, corners, recesses or other places
which are hard to reach.
Crevice nozzle brush attachment:
Place the brush attachment onto the crevice nozzle. The crevice nozzle brush
attachment cannot be used without the crevice nozzle! Use the brush attachment
to remove dust from delicate objects such as picture frames, lamp shades, keyboards,
books etc.
Nozzle for liquids:
Use the nozzle for liquids to remove dirt and small quantities of liquid on smooth
surfaces.
19 EN