Before Initial Use; Attaching The Wall Bracket With Charging Station; Charging Up The Battery - Cleanmaxx PC-P007E Mode D'emploi

Before Initial Use

1. Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Never remove the rating plate and any possible warnings!
2. Attach the wall bracket with charging station (10) (see the "Attaching Wall Bracket
with Charging Station" chapter).
3. Charge up the battery (4) (see the "Charging Up the Battery" chapter).

Attaching the Wall Bracket with Charging Station

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket with charging station.
If you are unsure whether the fastening material supplied is suitable for the wall, seek
advice from a specialist stockist.
■ Hang the wall bracket with charging station in a secure and solid place close to a
plug socket.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Drill holes at the correct distance into the wall and place dowels in them.
2. Screw the screws into the dowels. They should protrude by approx. 5 mm out of the
wall.
3. Hang the wall bracket with charging station in the screws.

Charging Up the Battery

• It is essential that you charge up the battery (4) fully before you fi rst use the
device in order to achieve the maximum charging capacity. It takes up to 5
hours to charge up the battery.
• The battery status is indicated by a battery symbol with three green bars in
the battery status display (1) of the device. When only the last bar is red, the
battery's charge is low and the battery should be recharged.
1. Switch off the device and remove the battery as follows: Press the release button on
the battery and pull the battery out of the device at the same time.
2. Before inserting the battery in the charging station, check whether the contacts are
clean and clean them if necessary.
20
19
21
3. Insert the battery into the charging station (10). The
18
two contacts on the battery must press against the
two contacts on the charging station and the battery
must be heard to engage in place.
4. Plug the barrel connector of the mains adapter (19)
into the connecting socket (6) on the charging station.
5. Connect the mains adapter to a properly installed,
easily accessible plug socket. The green operating
lamp (18) and the red charge control lamp (20) will
light up. The battery is being charged.
EN