Fitting The Wall Mounting Bracket; Sticking On The Wall Mounting Bracket - Cleanmaxx FOL- 818 Mode D'emploi

EN
NOTICE – Risk of Damage to Materi­
al and Property
■
The device should only be used if it
has been fully and correctly assem-
bled and is in good working order!
The dust container, the HEPA filter,
the cyclone insert and the metal filter
must be inserted and must not be
damaged! If dirt were to get inside
the main unit, this could damage the
motor.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Do not place any heavy objects on
the component parts of the device.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces. Do not wind
the mains cable around the mains
adapter.
■
When you pull the charger cable out
of the plug socket, always pull on the
mains adapter and never the mains
cable!
■
Do not subject the component parts
of the device to any impacts.
■
Do not use if there is visible damage
to the component parts of the device.
■
Ensure that there are no sharp objects
on the surface which is to be cleaned.
■
In the event of damage / faults, switch
the device off immediately.
20
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 20 04350_Inlay_de-en-fr-nl_A5_V1_1.indb 20
FITTING THE WALL
MOUNTING BRACKET
Please Note!
■
Make sure that the surface on which
the wall mounting bracket is fitted is
stable and that screws and anchors
which are suitable for the wall are
used. If in doubt, seek advice from a
specialist stockist.
■
Attach the wall mounting bracket near
to an easily accessible plug socket so
that the charger cable can be con-
nected.
■
Before drilling, ensure that there are
no pipes or cables behind the intend-
ed drilling point.
The device can be stored in the wall
mounting bracket (16) and charged up
there for its next use (Picture G).
L
The narrow end piece of the wall
mounting bracket is the cable
holder (Picture E).
The wall mounting bracket can be affixed
or screwed onto the wall. The items
supplied include 2 screws and anchors to
allow you to do this.
Sticking On the Wall Mounting
Bracket
Make sure that the spot on which the wall
mounting bracket is to be stuck is clean,
dry and free of dust.
1. Peel off the protective strips from the
adhesive pads on the back of the wall
brackets.
2. Stick the wall mounting bracket onto
the wall vertically, with the cable
holder pointing downwards, and press
it on firmly.
07.05.2020 15:50:45 07.05.2020 15:50:45