Before Initial Use; Mounting The Accessories - Cleanmaxx Z 06456 Mode D'emploi

Before Initial Use

CAUTION!
• Danger of suffocation from plastic fi lms and bags! Keep children and animals away
from the packaging material.
• Water residues in the water reservoir are attributable to the fact that this device has
been tested and do not constitute a defect.
• Unpack the items supplied and check them for completeness (see the "Items Sup-
plied" chapter) and transport damage. If the device, plug, mains cable or accessories
do have damage, do not use the device(!), but contact our customer service depart-
ment.
• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.

Mounting the Accessories

CAUTION!
• Always pull out the mains plug before you remove/change an attachment. Always pull
the plug and never the cable.
• Shortly after use, the attachment used may still be very hot. You should therefore wait
for a few minutes until it has completely cooled down before you detach it.
Long Nozzle Attachment
The long nozzle attachment (10) can be used anywhere. It is ideally suited to cleaning
heat-resistant surfaces in the kitchen and bathroom, corners and places that are hard
to reach.
Extension Hose
For better handling, you can use the extension hose (9) to extend the reach of the device.
06456_de-en-fr-nl_V1.indb 21 06456_de-en-fr-nl_V1.indb 21
21
The long nozzle attachment can have the brush attach-
ment (8) or the curved attachment (7) plugged onto it.
• Plug the long nozzle attachment as far as it will go onto
the steam nozzle (19) of the device or onto the extension
hose (9) and screw it on tight.
All attachments, apart from the fl oor attachment (4), can be
attached to the extension hose.
• Plug the extension hose as far as it will go onto the steam
nozzle (19) of the device and screw it on tight.
EN
03.07.2015 10:28:02 03.07.2015 10:28:02