Cleaning The Device; Floor Nozzle; Dust Container; Hepa Filter - Cleanmaxx FOL- 818 Mode D'emploi

9. You can press the switch (32) to
increase or reduce the power as
required.
When the fresh water tank is empty or the
dirty water tank is full, switch off the de-
vice with the ON / OFF button. Only then
should you fill or empty the tank (see the
"Cleaning the Device" chapter – "Dirty
Water Tank").
L
After use, place the device down
on a cloth as residual water may
escape from the wet cleaning
nozzle after it has been switched
off.
10. After every use, switch off the device,
fully empty all water tanks and clean
the dirty water tank as well as the
accessories of the wet cleaning nozzle
(see the "Cleaning the Device" chap-
ter).
11. Charge up the battery (see the
"Charging Up the Battery" chapter).

CLEANING THE DEVICE

Please Note!
■
During cleaning make sure that no
liquid gets into the main unit or inside
the wet cleaning nozzle.
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage
the surfaces.
• Remove hair and fluff from the
vacuum cleaner nozzles (5, 7, 9). The
floor nozzle can be opened to make it
easier to clean (see below).
• Wipe down the main unit (17), the
battery (1), the vacuum cleaner noz-
zles, the suction tube (4), the inter-
mediate piece (3), the wet cleaning
nozzle (8) and the wall mounting
bracket (16) with a damp, soft cloth if
required. Then dry with a cloth.
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 25 04350_Inlay_de-en-fr-nl_A5_V1_1.indb 25

Floor Nozzle

To make it easier to clean, the brush (28)
can be removed from the floor nozzle:
1. On the right on the bottom of the
floor nozzle is a catch (29) with a
slider. Slide it towards the
and flip up the catch.
2. Take out the brush and remove any
contamination.
3. Reinsert the brush. When you do this,
make sure that the end pieces of the
brush are plugged into the appropri-
ate holders.
4. Flip down the catch and slide the
slider towards the

Dust Container

1. Hold the device over an open dust-
bin.
2. Press the button (47) to open the dust
container. The bottom (35) of the dust
container will open and the dirt will
fall out.
3. Gently tap out the dust container
and if necessary clean the cyclone
insert (36) and metal filter (37) with a
soft brush.
4. Close the bottom again. It must en-
gage audibly.

HEPA Filter

1. Twist the HEPA filter cover (46) anti-
clockwise a little and take it off the
main unit.
2. Remove the HEPA filter, tap it out and
brush it down. Do not wet-clean the
HEPA filter!
3. Insert the HEPA filter into the main
unit, place on the HEPA filter cover
and twist it shut.
L
The HEPA filter may lose some of
its colour over time. This is normal
and does not have any adverse
effect on function.
EN
symbol
symbol.
25
07.05.2020 15:50:45 07.05.2020 15:50:45