Attaching The Wall Bracket With Charging Station; Charging Up The Battery - Cleanmaxx 09107 Manuel D'utilisation

Attaching the Wall Bracket with Charging Station

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket with charging station.
If you are unsure whether the fastening material supplied is suitable for the wall, seek
advice from a specialist stockist.
■ Hang the wall bracket with charging station in a secure and solid place.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Drill holes at the correct distance into the wall and place dowels in them.
2. Screw the screws into the dowels. They should protrude by approx. 5 mm out of the
wall.
3. Hang the wall bracket with charging station in the screws.

Charging Up the Battery

• It is essential that you charge up the battery (4) fully before you fi rst use the
device in order to achieve the maximum charging capacity. It takes up to 5
hours to charge up the battery.
• The battery status is indicated by a battery symbol with three green bars
in the battery status display (1). When only the last bar is red, the battery's
charge is low and the battery should be recharged.
1. Switch off the device and remove the battery as follows: Press the release button on
the battery and pull the battery out of the device at the same time.
2. Before inserting the battery in the charging station, check whether the contacts are
clean and clean them if necessary.
18
17
6. When only the green operating lamp is still lit, the battery is fully charged.
7. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
8. Press the release button on the battery and pull the battery out of the charging station.
9. Insert the battery into the device. The battery must be heard to engage in place.
21
3. Insert the battery into the charging station (10). The
16
two contacts on the battery must press against the
two contacts on the charging station and the battery
must be heard to engage in place.
4. Plug the barrel connector of the mains adapter (17)
into the connecting socket (6) on the charging station.
5. Connect the mains adapter to a properly installed,
easily accessible plug socket. The green operating
lamp (16) and the red charge control lamp (18) will
light up. The battery is being charged.
EN