Scheppach CSP41 Traduction Des Instructions D'origine page 54

11. Storage
m CAUTION
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Storing a chain saw for longer than 30 days re-
quires storage maintenance. Unless the storage
instructions are followed, fuel remaining in the carbu-
retor will evaporate, leaving gum-like deposits. This
could lead to difficult starting and result in costly re-
pairs.
1. Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
2. Start the engine and let it run until the unit stops
to remove fuel from carburetor.
3. Allow the engine to cool (approx. 5 minutes).
4. Remove the spark plug. You require the supplied
spark plug screwdriver combination tool for this.
5. Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber.
6. Pull starter rope slowly several times to coat in-
ternal components. Replace spark plug.
Putting the saw back into operation
1. Remove spark plug.
2. Pull starter rope briskly to clear excess oil from
combustion chamber.
3. Clean the spark plug and check that the electrode
gap is correct.
4. Prepare unit for operation.
5. Fill fuel tank with proper fuel / oil mixture.
6. Top up the chain oil in the chain oil tank.
12. Transportation
To transport the saw, empty the petrol tank. Re-
move coarse dirt from the saw with a bust or a
hand sweep
13. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
54 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
14. Troubleshooting
The table below contains a list of fault symptoms and
explains what you can do to rectify the problem if your
saw does not work properly. If the problem persists
after working through this list, please contact your
nearest service workshop.
m IMPORTANT!
Note regarding sending the saw in to a service centre:
For safety reasons, ensure that the saw does not
contain any residues of oil and petrol when sending
it back!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Chain chain, guide rail, chain oil, engine
oil, nail clasp, chain catcher, spark plug, air filter, fuel
filter, chain oil filter
* Not necessarily included in the scope of delivery!
Admitted saw chain and chain bar combination
Saw chain 3/8LP-57 (7910100735)
Guide bar AP16-57-507P (7910100736)
Saw chain Oregon 91P057X
Guide bar Oregon 160SDEA041