SilverCrest SPO 910 A1 Mode D'emploi page 10

NOTE
► The fi rst time the appliance heats up, a small amount of smoke and odour
may result from production-related residues. This is normal and is completely
harmless. Ensure suffi cient ventilation; for example, by opening a window.
5) Remove the plug from the mains power socket.
6) Allow the appliance to cool down for 30 minutes before dismantling and
cleaning it.
7) After heating the appliance for the fi rst time, clean it again as described
in the section "Cleaning and care".
Setting up and assembly
WARNING! RISK OF FIRE!
► Never set up the appliance underneath wall cupboards or next to curtains,
cupboard walls or other fl ammable objects.
► Always place the appliance on a heat-resistant surface.
1) Place the basic appliance 6 on a level surface. This must be heat-resistant,
splash-resistant and dry. Make sure that you do not place the appliance right
next to a wall or a cupboard.
3) Place the terracotta dome 2 carefully onto the basic appliance 6. The two
heating elements 7 and the baking tray 4 are now located in the baking
chamber of the pizza oven. Make sure that you place the terracotta dome 2
on the appliance so that none of the openings 3 are blocked by the vertical
part of the heating element 7. Otherwise, you will not be able to fi t a pizza
peel 8 through the opening 3.
SPO 910 A1
2) Put the baking tray 4 onto the basic
appliance 6: Turn the baking tray 4
around so that the embossed "UP"
is readable on the upper side. Then
push the baking tray 4 between
the two heating elements 7. The
semi-circular cut-out on the baking
tray 4 encloses the vertical part of
the heating element 7. Then place
the baking tray 4 onto the six sup-
ports provided. These supports fi x
the baking tray 4 in place so that
it cannot slip during operation.
GB │ IE │
7 ■