Publicité
POWR
1
2
REDUCTION DRIVE GEAR
4
3
Drive shaft installation
1. Install:
• Drive shaft
• Collar
NOTE:
Press the into the reduction drive gear case
with a pipe that is more than 30 mm (1.18 in)
long, and which has an outer diameter of
approximately 35 mm (1.97 in) and an inner
diameter of approximately 28 ± 0.5 mm (1.10 ±
0.02 in).
Drive coupling installation
1. Install:
• Drive coupling 1
NOTE:
While holding the drive shaft 2 with the rotor
holder 3, tighten the drive coupling with the
coupler wrench 4.
Coupler wrench:
YW-06551/90890-06551
Universal magneto and rotor
holder:
YU-01235
Rotor holder:
90890-01235
2. Install:
• Reduction drive gear housing
5-40
E
Publicité
Chapitres
