Handling Cameras - Corghi EXACT LINEAR PLUS Manuel D'utilisation

HANDLING CAMERAS

For all models in which it is expected to push
the movement of cameras and PAGE UP and
PAGE DOWN keys to move the beam so as to
vary the height.
-PAGE UP: rise the beam
- PAGE DOWN: low the beam.
If AUTOTRACKING is enabled, the beam automati-
cally follows the level of the targets
The rest position of cameras is at the top, therefo-
re before starting the work, wait for them to be up.
During ROC (jump - recall - thrust), cameras
move down to engage the 4 or 2 targets (in
2-target mode).
After engaging the targets, the automatic move-
ment of cameras is locked until the data summary
page is shown.
The automatic movement of the beam is always
reactivated when the data summary page is
accessed.
Now it is possible to move the lift up, cameras
will follow the targets.
Operator's manual EXACT LINEAR
It is always active even when moving from front
to rear side.
When the lift has been moved up, after engaging
the targets again, cameras are locked in the
position reached.
The icon signals whether the tracking is active
or not.
- Stopped
If you want to move the lift again, there are two
options:
1- Activate the tracking by clicking on the stop
icon which will change its status to
and then move the lift.
2- Move the lift, this will cause a link error.
Press PAGE UP to search for the targets by mo-
ving up or PAGE DOWN to search for the targets
downwards.
- tracking active.
EN
73