Corghi EXACT LINEAR PLUS Manuel D'utilisation page 55

Last step Returns to the previous pro-
gramme step.
Skip operation Skips to the next pro-
gramme step without requiring execution of the
current step.
Back to selection Moves the active cursor
from the icon bar to the working zone.
Increase Increases the value of the
selected object (for example, it increases the rim
diameter to the value above).
Decrease Decreases the value of the
selected object (for example, it decreases the rim
diameter to the value below).
Exit Ends the current operation.
Next page Displays the sequence of pages
of the on-line help function. The icon is only active
when there is more than one page.
Save Saves the vehicle's pre-adjustment
values.
Save axle weight Saves the weight of the
axle being measured.
Yes Confirms the selection made or the
value entered.
No / Abort Aborts the selection made or
the value entered.
User code For changing the user code
Manufacturer's Set-up Changes the set-up
settings, entering the factory defaults.
Special functions
Single value Shows only one angle of the
selected axle at a time.
Operator's manual EXACT LINEAR
Maximum steering angle Activates and
deactivates the maximum steering angle procedure.
2WS steering angle Recalls the steer-
ing angle procedure for vehicles with 2-wheel
steering.
4WS steering angle Recalls the steer-
ing angle procedure for vehicles with 4-wheel
steering.
Adjustment with car lifted Starts the
procedure for adjusting an axle with the car lifted.
End of adjustment with car lifted Ends
the procedure for adjusting an axle with the car
lifted, lower the vehicle.
Chassis input degrees Manual com-
pilation of the chassis height record with data
in degrees.
Chassis input mm Manual compilation of
the chassis height record with data in millimetres.
Menu management
Open menu Opens the menu containing
the additional icons for which there is no room
in the icon bar.
Recall other icons Displays the second
set of icons in the sub-menu.
Close menu Closes the menu containing
the additional icons.
RUNOUT Compensation
Push Mode ROC Recalls the push
compensation procedure that does not require
vehicle lifting.
ROC skip Continues vehicle align-
ment operations, skipping the compensation
procedure.
EN
55