Corghi EXACT LINEAR PLUS Manuel D'utilisation page 65

13) Front axle measurement.
14) Print out of data measured.
(1) Switching on the aligner
IMPORTANT For the first start-up, the "Monitor
adjustment" chapter must be read.
Turn on the device using the main switch.
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
In this stage, the central unit runs a functional
self-diagnostics test and loads the operating
system; if everything is in order, the "Main menu"
screen will appear (Fig. 20).
If the user set-up field "Alignment customisation
procedure/Lift test" = YES, the programme will
automatically open the "Lift Check" page, see
"Lift and Target Check" section.
(2) Work start selection
Initial page
start a new alignment work.
restarts the previous job.
and
"demo" mode, for which the targets are not
required.
ATTENTION: Some selectable programs can
not be active or activable.
The "demo" mode is indicated by the
symbol in the status bar.
and
maintenance utilities, and wheel aligner cus-
tomisation.
ends execution of the program, shuts
down all the applications open and switches off
the wheel aligner.
WARNING
before switching off the wheel aligner, always
shut down the active programs and operating
system correctly.
Operator's manual EXACT LINEAR
enable and disable the
access the service and
(3) Databank (Fig. 21)
/ Job record(Fig. 32)
To access this function from the rest of the pro-
gramme select the
Select the vehicle from the databank, using the
keys in the following way: ↓, ↑, PAGE↓, PAGE↑,
←, → and the letter keys to scroll through the
trademarks and model descriptions;
↵ to confirm the vehicle selection.
During selection, the vehicle code is shown in
the status bar.
The model of the vehicle selected will be loaded
in the "Vehicle name bar", which contains the
name of the market set while selection is in pro-
gress. All the cars and vans up to and including
3500 kg are shown on the screen.
recalls the market selection. The screen
only shows the vehicles on sale on the selected
market. allows selection of the reference
databank. The vehicles belonging to the user
databank are marked by the
displays the vehicle descriptions sup-
plied by the manufacturers for wheel alignment
operations.
displays the commercial descriptions
of the vehicles.
accesses compilation of the job record.
If the user set-up field "Alignment procedure
customisation / vehicle selection mode" = "Job
record" the data input form will be displayed.
Selection of the vehicle from the databank can
be selected from the record.
Different job record options are available in the
set-up, "Job record / type" field.
Key to Databank abbreviations
/ Separates different models
4WD - 4x4 Four Wheel Drive
4WS Four wheel steering
ALU Lightweight alloy wheels
DR Door
CAB Enclosed light commercial ve-
icon or the F8 key.
symbol.
EN
65