Personal Computer; Monitor Adjustment; Operator Interface - Corghi EXACT LINEAR PLUS Manuel D'utilisation

L) Vehicle name bar: displays the name of the
vehicle selected from the databank. During
selection of the vehicle from the databank,
it shows the market selected.
M) Status bar: displays system messages.
N) Axle value difference: window containing the
value and databank reference for the differ-
ence between the right-hand and left-hand
values of the angle measured. The window
only appears when the databank contains a
reference value.
O) Operating Zone: part of the screen which
displays the working information.
Target (Fig. 3)
A) The aligner has 4 lightweight, high-resolution
targets, with a front infrared filter giving
excellent protection against the sun's rays.
Each target can be detached from its bracket;
this means the aligner can be used with
different types of bracket.
Clamps
The clamps function in the same way as ordinary
self-centring clamps.
Use the handle (A Fig. 3) to fix the clamp to the
rim or remove it.

PERSONAL COMPUTER

Turn on the aligner using the main switch.
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire wheel
aligner, can only be switched off using the com-
mand provided in the wheel alignment program.
IMPORTANT
Switching off the personal computer without
using the command provided may damage the
software installation.
IMPORTANT
When the wheel aligner is switched off using
the software command, the PC, the monitor and
the printer switch to standby status. To switch
off these devices completely, use either the
relative on and off buttons, or the PC feeder
switch (switch marked C turned to 0), or cut off
the wheel aligner power supply at the mains.
Operator's manual EXACT LINEAR
Keep the original MS-WINDOWS and aligner
software CD-ROMs for future system updates.
IMPORTANT
The software on the CD-ROM is the property
of the producer and can be used only with the
personal computer supplied with the equipment.

MONITOR ADJUSTMENT

With the personal computer turned on, operate
the monitor controls, and for detailed instructions
refer to the monitor operator's manual.

OPERATOR INTERFACE

Commands and information for moving around
the vehicle wheel alignment program.
Icons
An icon is a key on the screen which performs a
specific action when it is selected. This function
is the same throughout the procedure.
The icon's function is identified by a graphic
symbol; a brief comment is also provided in the
feedback bar.
Move to the icons, using the keys ←, →, ↑, ↓ and
select them with ↵.
If the icon selected has a sub-menu, it will open
vertically and the icon selected will be replaced
by . Use this icon or the ESC key to close
the menu.
identifies additional icons in the menu
for display.
Icons which are not active are plain grey in colour.
Main menu
Start Begins the vehicle alignment
procedure.
Alignment procedure Selects the
wheel alignment procedure: quick, complete or
customised.
EN
53