Corghi EXACT LINEAR PLUS Manuel D'utilisation page 54

Databank and job management Tools for
management of the jobs archive and user databank.
Set-up and maintenance Gives access
to the utility functions for wheel aligner set-up
and maintenance.
Service programs Gives access to
the wheel aligner service and troubleshooting
functions.
Last job Restarts the wheel alignment
procedure by loading the data of the job just
completed.
Shutdown Activates the programme
closure and wheel aligner switch-off procedure.
Help Recalls the information for the
current video page to the screen.
The on-line instructions back up the Operator's
Manual but do not replace it in all respects.
Programme step recall
Diameter selection Recalls input of the
rim diameter to be used in toe measurements
in millimetres / inches.
Chassis height For vehicles where this
is necessary, recalls input of the chassis heights
necessary to obtain the databank references
Steering angle Recalls the steering
lock procedure for measurement of the caster,
king pin, steering angle difference at 20° and
maximum steering angle.
Data summary Recalls the summary of
the vehicle data.
Front axle Recalls the front axle adjust-
ment step.
Rear axle Recalls the rear axle adjust-
ment step.
54
Data summary and printout Recalls
the job data summary, printout and save step.
End of session Ends the current job
and returns to the main menu.
Vehicle adjustment Selects the help
function for adjustment of the vehicle. Only the
help selections available are active.
Vehicle selection Recalls selection of
the vehicle from the databank.
Databank data summary Recalls the
full summary vehicle's databank references.
Chassis situation Recalls the vehicle
chassis situation step.
Toe curve Recalls the toe curve checking
and adjustment procedure.
Distronic Adjustment Recalls the align-
ment screen for the equipment for adjusting the
Mercedes "Distronic" anti-collision radar system.
Log Recalls the logs screen. Active
for calibration procedures and other utility
programs.
Chassis misalignment Recalls the screen
.
that supplies the estimate of the vehicle's degree
of "dog tracking".
Visual check Recalls the procedure for
visual checking of the vehicle.
Vehicle weight Recalls the procedure for
acquiring and adjusting the vehicle's axle weight.
General functions
Continue Moves on to the next pro-
gramme step in the pre-set sequence.
Operator's manual EXACT LINEAR