Setting The Display Alignment (D.dir); Setting The Digital Indicator (D.uni) - JUMO DELOS HP Notice De Mise En Service

7 Startup
7.15

Setting the display alignment (D.Dir)

Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "D.Dir" appears in the bottom line.
3. "Press" (- flashing, D.Dir static)
or
7.16

Setting the digital indicator (D.Uni)

Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "D.Uni" appears in the bottom line.
3. "Press"
Uni.t = The measured value is displayed in the selected unit,
see chapter 7.4 "Select the unit of measured (Uni.P)", page 24
or
34
std = Standard = Device vertical
turn = rotated = Device overhead
std
Uni.P = Unit of pressure set as for "Uni.P,"
see chapter 7.4 "Select the unit of measured (Uni.P)", page 24
Pro.2 = Percentage of the scaled measuring range = "Sc.Hi" minus "Sc.Lo,"
see chapter 7.8.1 "Setting the scaling start value (Sc.Lo)", page 28, and
chapter 7.8.2 "Setting the scaling end value (Sc.Hi)", page 28
std