Setting The Switching Point (B.sp); Setting The Release Point (B.rsp); Setting The Switching Differential (Hysteresis) (B.hys) - JUMO DELOS HP Notice De Mise En Service

7 Startup
7.11

Setting the switching point (B.Sp)

 chapter 7.10 "Setting the switching function (B.Fct)", page 30
Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "B.Sp" appears in the bottom line.
3. "Press" (- flashing, B.SP static)
NOTE!
The value is entered "digit-by-digit"!
7.12

Setting the release point (B.RSp)

 chapter 7.10 "Setting the switching function (B.Fct)", page 30
Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "B.RSp" appears in the bottom line.
3. "Press" (- flashing, B.RSP static)
NOTE!
The value is entered "digit-by-digit"!
7.13

Setting the switching differential (hysteresis) (B.HYS)

 chapter 7.10 "Setting the switching function (B.Fct)", page 30
Setting range:
Default setting:
32
0 to 100% of the nominal measuring range
50% of the nominal measuring range
0 to 100% of the nominal measuring range
40% of the nominal measuring range
0 to 100% of the nominal measuring range
40% of the nominal measuring range