Setting The Filter Time Constant (Damping) (Damp); Setting The Output Signal (S.type) - JUMO DELOS HP Notice De Mise En Service

7 Startup
7.6

Setting the filter time constant (damping) (DamP)

The filter time constants (damping) can be used to "damp" the measured value.
Small filter time constant: The measured value is updated faster.
Large filter time constant: The measured value is updated slower.
The value is entered in seconds with two decimal places.
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "DamP" appears in the bottom line.
3. "Press"
NOTE!
Attenuation affects the behavior of the display's analog output, and the switching outputs.
7.7

Setting the output signal (S.Type)

1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "S.Type" appears in the bottom line.
3. "Press"
Example:
4.20 A = (Output signal of 4 to 20 mA)
0.20 A = (Output signal of 0 to 20 mA)
0.10 U = (Output signal of 0 to 10 V)
26