Cancel Operation; Select The Unit Of Measured (Uni.p) - JUMO DELOS HP Notice De Mise En Service

7 Startup
7.3

Cancel operation

1. Press the combination tool for more than 3 seconds or
2. wait for a "timeout" (no actions for more than 60 seconds)
7.4

Select the unit of measured (Uni.P)

1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "Uni.P" appears in the bottom line.
3. "Press" (bar flashing, Uni.P static)
The measured pressure is displayed in bar.
4. "Turn" to the desired pressure unit, display measured value as percentage
 chapter 7.16 "Setting the digital indicator (D.Uni)", page 34
The measured pressure is displayed in Megapascal (MPa).
5. "Turn"
The measured pressure is displayed in psi.
Confirm the setting: "Press" until the display stops flashing.
NOTE!
See chapter 7.16 "Setting the digital indicator (D.Uni)", page 34
24