Displaying The Software Version Of The Operating Unit (Sw.di); Displaying The Software Version Of The Signal Unit (Sw.si) - JUMO DELOS HP Notice De Mise En Service

Pro.2 = The measured value is displayed as a percentage of the scaled measuring range,
, see chapter 7.8.1 "Setting the scaling start value (Sc.Lo)", page 28 and chapter 7.8.2 "Setting the
scaling end value (Sc.Hi)", page 28
Example:
The measuring range of the device has been set to 0 to 400 bar; the scaled measuring range is 400 bar.
When the device measures a pressure of 200 bar, 50% is displayed.
7.17

Displaying the software version of the operating unit (SW.Di)

Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "SW.Di" appears in the bottom line.
3. "Press" (A 01 alternating)
7.18

Displaying the software version of the signal unit (SW.Si)

Setting range:
Default setting:
Setting
1. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
2. "Turn" until "SW.Si" appears in the bottom line.
3. "Press" (U 01 alternating)
Read only
-
Read only
-
7 Startup
35