Startup; Quick Introduction - JUMO DELOS HP Notice De Mise En Service

7

Startup

7 Startup
7.1

Quick introduction

NOTE!
This is a proposal to be able to configure the device reliably within a short time. When checking the set-
ting possibilities specified in this list prior to starting configuration, timeouts can be avoided during con-
figuration.
1. Mount the device.
 chapter 4 "Mounting", page 10
2. Install the device.
 chapter 5 "Electrical connection", page 13
3. Unlock the device.
 chapter 7.2 "Unlocking the device (enter the code).", page 23
4. Select the unit of the measured value.
 chapter 7.4 "Select the unit of measured (Uni.P)", page 24
5. Set the output signal.
 chapter 7.7 "Setting the output signal (S.Type)", page 26
6. Set the output signal scaling (restrict the measuring range).
 chapter 7.8 "Setting the output signal scaling", page 27
7. Set the switching function.
 chapter 7.10 "Setting the switching function (B.Fct)", page 30
8. Set the switching point.
 chapter 7.11 "Setting the switching point (B.Sp)", page 32
22