Installation Of A Flow Transmitter Se36 With Sensor-Fitting S070 Or S077 In A Pipe - Burkert 8026 Guide Rapide

Masquer les pouces Voir aussi pour 8026:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.4.3 complete the installation of the 8036
Wire the device (see chap. 7.6) and supply power to the device.
Set the K-factor or determine it through a Teach-In procedure
(see chap. 8.8.8).
7.5
installation of a flow transmitter
SE36 with sensor-fitting S070 or
S077 in a pipe
Danger
risk of injury due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
Follow the next steps to install the flow transmitter SE36 properly on
the sensor-fitting S070 or S077, mounted in the pipe:
7.5.1 install the sensor-fitting S070 or S077
in a pipe
Select a sensor-fitting S070 or S077 adapted to the fluid
viscosity.
19
English
Type 8026 - 8036 - SE36
Installation and wiring
To select a fitting, please refer to the chart in the technical
data sheet of the related fitting.
Install the sensor-fitting S070 or S077 in the pipe so that the
oval gear axes are in the horizontal plane (see Fig. 9).
Fig. 9: 
The oval gear axes must be horizontal (seen from the front)The 
oval gear axes must be horizontal
Correct
Incorrect

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8036Se36

Table des Matières