Adjustment And Commissioning; Safety Instructions - Burkert 8026 Guide Rapide

Load 1
white
2
blue
3 1
4
grey
black
- +
12-36 V DC
1 4-20 mA input
st
(external instru-
ment)
Fig. 21: PNP wiring of both transistor outputs and wiring of both current
outputs in sourcing mode, on a version with 2 fixed connectors
(parameter setting "PNP/source")
26
Load 2
white
2
brown
blue
1 3
4
black
-
- +
2 nd 4-20 mA input
Power supply
(external instrument)
English
8 ADjuSTmEnT AnD
commiSSioninG
• The settings can only be done on a device with a display
module.
• Do not remove the display module while making the set-
tings on the device.
8.1 Safety instructions
Warning
risk of injury due to non-conforming adjustment.
Non-conforming operating could lead to injuries and damage the
device and its surroundings.
▶ The operators in charge of adjustment must have read and
understood the contents of this manual.
▶ In particular, observe the safety recommendations and intended
use.
▶ The device/installation must only be adjusted by suitably trained
staff.
+
Type 8026 - 8036 - SE36

Adjustment and commissioning