Falcon Professional+ 110 Mode D'emploi page 26

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
16. To Change an Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until that hook is released. Proceed to
the next hook and release it in a similar way, and so on. Use
force if the hooks are stiff, as the old seal will be discarded.
ArtNo.320-0005 Oven door rubber seal
When fitting the new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door, snapping in each hook in turn.
17. To Replace the Grill Element
Disconnect from the electricity supply.
Remove the grill pan from the grill chamber. From inside the
grill compartment, remove the enamelled front shield from
the grill roof, by undoing the two screws and washers. Remove
two screws and washers securing the grill element front
support. Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from the
element terminals noting their position. If it is not possible
to disconnect the leads in this way, pull cooker forward to
gain access to the rear, remove screws securing the electric
cover to the back sheet and remove cover and disconnect the
terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.
18. To Remove Right-Hand Oven Inner Back
Open right-hand oven door and remove the screws and
washers securing the inner back to the back of the oven.
ArtNo.320-0020 Oven back fixing screws
Carefully lift away the inner back. Reassemble in reverse
order making sure that the four screws and washers are fully
tightened.
All manuals and user guides at all-guides.com
24
19. To Change the Fan in the Right-hand Oven
Disconnect from the electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover. Disconnect the three terminals connected
to the fan noting their position. Remove the oven inner
back (see 18). Hold the fan blade and remove the centre nut
(left-hand thread) two brass washers, fan blade and Circlip.
Unscrew the fan retaining nuts and washers (three off each)
and lift the fan away from the rear of the cooker. Fit the new
fan and reassemble in reverse order. Check the operation of
the oven.
20. To Remove an Oven element Thermal Cut-Out
Disconnect from the electricity supply.
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cut-out is located on the
earth plate beside the oven element connections. Disconnect
the cut-out wiring. Undo the fixings that secure the cut-out to
the earth plate and remove. Fit the replacement control and
re-assemble in reverse order.
21. To Remove the Right-Hand Oven Element
Disconnect from the electricity supply.
Remove oven inner back (see 18).
��������������������
ArtNo.321-0005 Fan oven element
Remove the two screws from the top of the element and the
one from the bottom of the element inside the oven. Lift the
element out carefully, disconnecting the terminals connected
to the element (noting their positions). If it is not possible to
disconnect the leads in this way, pull the cooker forward to
gain access to the rear, remove the screws securing the electric
cover to the back sheet, remove the cover and disconnect the
terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the oven.