Falcon Professional+ 110 Mode D'emploi page 22

Check the appliance is electrically safe and gas sound when you have finished.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical Engineers
(I.E.E.) regulations and also the local electricity supply
company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED
Note:
The cooker must be connected to the correct
electrical supply as stated on the voltage label on
the cooker, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles.
The cooker must not be connected to an ordinary
domestic power point.
L
N
ArtNo.000-0010 Electrical connections single-phase
6mm 2
230Vac 50Hz
Single-phase
L1
N
L3
L2
6mm 2
ArtNo.000-0011 Electrical connections 3-phase
L1 L2 L3
3N ac
230/400V 50Hz
Three-phase
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect the
mains cable to the correct terminals for your electrical supply
type (see fig.). Check that the links are correctly fitted and that
the terminal screws are tight. Secure the mains cable using
the cable clamp.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined use of
your cooker and other domestic appliances may occasionally
cause nuisance tripping.
All manuals and user guides at all-guides.com
INSTALLATION
N
L
N
Hotplate
Check each burner in turn. Push in tap and turn to the large
flame symbol. Press ignition switch on fascia panel.
Oven check
Set the clock to the time of day.
When the clock is first connected the display will flash ( 0.00)

and ( ) alternately.
2-button clock set TOD
To set the clock to read the time of day turn and hold the
Timer knob to the clock symbol (
turn the Adjusting knob left or right until the clock shows the
time of day. Remember this is a 24-hour clock. Let go of the
Timer knob and it will spring back to the vertical oven manual
setting.
Turn on the oven and check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the oven.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws.
ArtNo.110-0001 - Securing the 110 plinth
Customer care
Please complete your details in this Guide, inform the user
how to operate the cooker and hand over the Instructions.
Thank you.
20
ArtNo.300-0002
 ) and at the same time