Falcon Professional+ 110 Mode D'emploi page 19

Check the appliance is electrically safe and gas sound when you have finished.
Positioning the Cooker
The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
����
���
ArtNo.110-0035 110DF Prof+ min spacings
The hotplate surround should be level with, or above,
any adjacent work surface. A gap of 75mm should be left
between each side of the cooker ABOVE the hotplate level
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top of
the hotplate and a horizontal combustible surface.
�����������
���������
ArtNo.110-0003 - Min positions above cooker
*Any cooker hood should be installed in accordance with the
hood manufacturer's instructions.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65°C above room temperature.
For safety reasons curtains must not be fitted immediately
behind the cooker.
We recommend a gap of 1110mm between units to allow
for moving the cooker. Do not box the cooker in; it must
be possible to move the cooker in and out for cleaning and
servicing.
All manuals and user guides at all-guides.com
INSTALLATION
����
�����
���
���
�����
���
�����
���
17
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open. The
actual opening of the doors is slightly less but this allows for
some protection of your hand as you open the door.
�������
�������
ArtNo.110-0005 110 door clearances
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not
fit through a door in its outer packaging). Cut the banding
straps and lift the cardboard box off the cooker, leaving
the cooker standing on the base packaging. See the loose
unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.

We recommend two people manoeuvre the cooker. Ensure
that the floor covering is firmly fixed, or removed to prevent
it being disturbed when moving the cooker around. You will
need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
ArtNo.010-0001 Removing the packaging
Repeat from the front and remove the front half of the poly
base. Pull the drawer out to its furthest point.
ArtNo.340-0002 110 removing the drawer