Falcon Professional+ 110 Mode D'emploi page 21

Check the appliance is electrically safe and gas sound when you have finished.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
�
�����
ArtNo.110-0010 Fitting the stability bracket
�����
�����
A - Levelling rollers, B - Levelling feet,
D - Pencil line on the floor
ArtNo.020-0013 Stability bracket
1. Place the cooker in its intended position and level it.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left-hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate the
front edge of the bracket. Fix the bracket to the floor.
6. Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension and
assemble the stability bracket to this height. (i.e. from
floor level to underside of the top member) and ensure
the bracket does not foul the oven burner assembly.
Gas Connection
Must be in accordance with the relevant standards. A hose is
not supplied by with the cooker. Hoses may be purchased at
most builders' merchants.
The Gas supply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the supply
point.
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. Ideally the house supply bayonet should be in
the shaded area shown in the diagram. Although a 900mm
hose can be used, a 1250mm hose will allow slightly more
All manuals and user guides at all-guides.com
INSTALLATION
�
� �
C - Wall face,
19
flexibility in the positioning of the bayonet and make moving
the cooker easier. The hose should be fitted so that both inlet
and outlet connections are vertical so that the hose hangs
downwards.
The connector is located just below the hotplate level at the
rear of the cooker.
���
���
���
���
�
ArtNo.110-0011 110 DF gas hose connections
A - Appliance gas inlet , B - Position for gas supply connector;
alternatively, connect it from the side
 For Natural Gas the flexible hose must be in
accordance with B.S.669.
 For LP Gas it should be capable of 50mbar pressure,
70°C temperature rise and carry a red stripe, band or
label.
If in doubt contact, your supplier.
Screw connect the threaded end of the hose into the gas inlet
in the underside of the connector block on the back of the
cooker.
After completing the gas connection, check the cooker is gas
sound with a pressure test.
Pressure testing
The gas pressure can be measured at one of the centre
hotplate burner injectors (not the Wok burner). Lift off a
burner head and fit the pressure gauge to the injector. Turn
on and light one of the other hotplate burners. Turn on the
control knob for the burner with the pressure gauge fitted to
let gas through.
Pressures
Natural Gas
Butane
20mbar
Propane
Turn off the burners. Reassemble burner top, making sure it is
reassembled in the correct way on the burner body.
�
LP Gas cookers
29mbar
37mbar