Troubleshooting - Falcon Professional+ 110 Mode D'emploi

If you need to remove the side rails to facilitate the cleaning
of the grill chamber, you can unhook them from the grill
chamber sides and wipe the sides clean with a soft cloth and
mild detergent.
ArtNo.331-0005 Removing the grill rail
Do not use any abrasive substances. DO NOT put the side
runners in a dishwasher.
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, ensure that the wide rim is at the
front:
ArtNo.331-0006 Grill pan plan
Control Panel and Doors
Avoid using any abrasive cleaners, including cream cleaners,
on brushed Stainless Steel surfaces. For best results, use a
liquid detergent.
The control panel and knobs, and doors, should only be
cleaned with a soft cloth wrung out in clean hot soapy water.
After cleaning, polish with a dry cloth.
Ovens
The ovens have removable panels that have been coated with
a special enamel that partly cleans itself. This does not stop
all marks on the lining, but helps to reduce the amount of
manual cleaning needed.
The Cook & Clean panels work better above 200°C. If you do most
of your cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water. The
panels should then be dried and replaced and the oven heated
at 200°C for about one hour. This will ensure the Cook & Clean
panels are working effectively.
DO NOT use steel wool, oven cleaning pads, or any

other materials that will scratch the surface.
All manuals and user guides at all-guides.com
13
Removing the Oven Linings
Some of the lining panels can be removed for cleaning. You
will need to remove the shelves before removing the panels.
Each side of the oven is fixed with four fixing screws. You
don't have to remove the screws to remove the oven linings.
Simply lift each side panel upwards and they will slide off the
screws. Then pull them forwards:
ArtNo.320-0008 Removing the oven lining
Once the linings are removed, the oven enamel interior can
be cleaned.

Troubleshooting

Noisy oven fan.
The tone of an oven fan may change as the oven heats
up – this is perfectly normal.
Grill not cooking properly.
Are you using the pan and trivet supplied with the
cooker? Is the pan being used on the runners, not the
floor of the compartment? Is the grill tray pushed fully
back to stop?
The knobs get hot when I use the oven or the grill.
Can I avoid this?
Yes, this is caused by heat rising from the oven or the
grill, and heating them up. Don't leave the oven door
open. Make sure that the grill pan is pushed right back to
the 'back stop' when grilling.
Always grill with the grill compartment door open.
If there is an installation problem and I don't get
my original installer to come back to fix it, who
pays?
You do. Service organisations will charge for their call-
outs if they are correcting work carried out by your
original installer. Therefore, it's in your own interest to
keep track of this installer so that you can contact them
as required.
Power failure.
In the event of a failure in the electrical supply,
remember to reset the clock to ensure that the timed
oven continues to operate.