Falcon Professional+ 110 Mode D'emploi page 20

Check the appliance is electrically safe and gas sound when you have finished.
Fit the levelling tool on the rectangular adjuster as shown
below.
ArtNo.010-0008 Lowering the front rollers
LOWER THE FRONT ROLLER by doing 14 complete (360°) turns
clockwise. (This means turning and removing the levelling
tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut as
shown below.
ArtNo.010-0002 Rear roller nut
Make 10 complete (360°) turns clockwise. (This means turning
and removing the levelling tool 20 times).
ArtNo.010-0003 Lowering the rear rollers
x10
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push the
cooker backwards out of the base pack. Push the cooker close
to its final position, leaving just enough space to get behind
it.
All manuals and user guides at all-guides.com
INSTALLATION
� ��
18
ArtNo.010-0009 Pushing the cooker
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of these
instructions.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust the
height of the rear of the cooker use the levelling tool supplied
to turn the adjusting nuts at the front bottom corners of the
cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfied with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the front
roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of the
tool facing the rear of the cooker, so that the customer can
use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push in.