Control Unit; Ac Electrical Cord (2M) - NSK Surgic XT Plus Mode D'emploi

5. Installation
5-1 Connecting the Motor Cord
Align the [ ] mark on the Micromotor cord with [
mark on the Control Unit; push the Base of Micromotor
Cord Plug into the socket until the locking joint 'clicks'
into place.
To disconnect the plug; pull back the Lock Joint, pull
further to disconnect the cord (Fig. 2).
5-2 Connecting the Foot Control
Face the screw on the Foot Control Cord Plug downward
then insert the plug into the Foot Control Cord connector
socket on the Control Unit. Secure the plug by fastening
the Lock Nut. Refer Figs. 3 & 4.
5-3 Connecting the AC Electrical Cord
Correctly align then insert the AC Electrical Cord into the
AC Electrical Cord Connection at the back of the Control
Unit (Fig. 5).
5-4 Installing the Irrigation Tube
Mount the Irrigation tube. Ensure the pump cover lever is
in the 'OPEN' position, with the Irrigation tube 'Needle'
towards the backside of the Control Unit. Position the
stoppers of the tube assembly in to the Tube Guide
securely. (Fig. 6)
]
Base of Micromotor Cord Plug
Lock Nut
Screw
Tube Guide
Fixed Position
7
Case Marking
Lock Joint Cable Marking
Pump Cover
Fixed Position
"Control Unit" Direction
Stopper
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
"Needle" Direction
Fig. 6