NSK Surgic XT Plus Mode D'emploi page 5

3. Control Unit with an Irrigation Pump
Calibration Load
Coolant Flow key
Gear Ratio Key
System Key
Description of Operation
Keys on the Control Unit
(1) Program Key
Use to Cycle through available programs. Press [+] key to ascend and [-] key to descend program number. You will
find all program numbers sequentially by pressing keys.
(2) Speed Key
Use to set the Micromotor speed. Press [+] key to increase, and [-] key to decrease speed. (When the upper and
lower speed limits are reached an audible alarm 'beep' is sounded).
(3) Torque Key
Use to set the torque range. Press [+] key to increase and [-] key to decrease torque range. (When the upper and
lower torque range limits are reached an audible alarm 'beep' is sounded). The torque range setting should be
selected according to the attached handpiece gear ratio.
(4) System Key
Use to activate calibration cycle of the handpiece before use.
(5) Gear Ratio Key
Use to set gear ratio of the attached handpiece before use. Repeat press this key until the LCD display indicates the
correct gear ratio of the handpiece.
(6) Coolant Flow Key
Use to select 6 levels of coolant solution flow from 0 to 5, repeat press key to cycle through coolant flow levels.
(7) FWD-REV Key
Use to select the direction of rotation. Press this key once to change the rotational direction. (Once in reverse the
Control Unit audibly warns with a 'beep')
(8) Memorize Key
Use to memorize the program parameters set by the operator. Press & hold this key for approx. 1 second to memorize
parameters. When beep sounds, the new program parameters have been memorized.
Irrigation Pump
Program Key
Speed Key
Torque Key
Micromotor Cord
Connection socket
Memorize Key
FWD-REV Key
4
Fuse Holder
Main Power Switch
AC Electrical Cord Connection socket
Coolant Solution Hanger Post Holder
Foot Control Cord connection socket