Irrigation Tube - NSK Surgic XT Plus Mode D'emploi

5-6 Insertion of the irrigation Tube
1) Close the Tube Clamp, between the Irrigation Tube Needle and the
Irrigation Pump, as shown in Fig.12.
2) Insert the Irrigation Tube Needle into the Bottle Cap. (Fig.13)
3) Open the Tube Cap to supply air into the bottle. (Fig.14)
4) Open the Tube Clamp.
CAUTION
Do not operate the Irrigation Pump if the tube is bent or the
Tube Clamp is in the closed position. This could cause the
tube to burst or slip out of the bottle.
5-7 Compatibility check of Internal Irrigation Nozzle/Drill
Internal irrigation nozzles accompanied with this product; is not necessarily fitted into all the drills on the market.
Follow the instructions given below for confirmation prior to use.
Failure to do so or to fit the internal irrigation nozzle into drills may cause a leakage of saline solution, which will result
in problems such as rust or sudden stop of equipment during use.
Instructions:
1) Attach a bottle of saline solution to the Control Unit.
2) Connect the Internal Irrigation Nozzle into the tip of the irrigation tube.
3) Insert the Internal Irrigation Nozzle into the drill from the back (Fig 15).
4) Purge at "Maximum" for 5 seconds.
Points to be checked :
Cleanliness of the saline solution coming out from the drill; if solution is colored there could be rust inside of the
drill. If so renew the drill.
Water Flow; if the flow is low and/or the flow from the drill is asymmetric, renew the drill.
No water leakage between Internal Irrigation Nozzle and drill
Before use, ensure no water is leaking from the entry point of irrigation nozzle, a broken seal or no seal in the drill
may be the cause. Replace the drill even if its new, saline solution ingress into handpiece will cause malfunction.
Irrigation
Tube Needle
Tube Cap
Internal Irrigation Nozzle Internal Irrigation Nozzle Internal Irrigation Nozzle
Drill Drill Drill
9
Tube Clamp
Fig. 12
Bottle Cap
Fig. 13
Fig. 14

Irrigation Tube

Irrigation Tube Irrigation Tube
Fig. 15