Checchi & Magli DUAL 12 GOLD Manuel D'utilisation Et D'entretien page 89

Replacing the flexible plate
D
UN41-0566BN
For this operation, proceed as outlined below.
1) Unscrew the screw (F).
2) Remove the casing (G).
3) Loosen the wing nut (A).
4) Turn the lock lever (B).
5) Push the share forwards and turn it so it is facing
downwards.
6) Release the springs (C).
7) Unscrew the screws (D).
8) Remove the flexible plate (E).
9) Fit the new flexible plate in position.
10) Tighten the screws (D) lightly.
11) Hook up the springs (C).
12) Make sure the flexible plate is centred (see "Sym-
metrical adjustment of the flexible plate with the
ploughshare").
13) Check the position of the flexible plate with respect
to the share (see "Adjusting the flexible plate posi-
tion with the ploughshare").
14) Tighten the screws (D).
15) Refit the share in the work position.
16) Tighten the wing nut (A).
English language
INFORMATION CONCERNING REPLACEMENTS
H
E
NOTICE
Check that the Plant Control device (H) is inside the
share.
17) Position the casing (G).
18) Tighten the screw (F).
41
F
G
C
8
A B
Use and maintenance