Checchi & Magli DUAL 12 GOLD Manuel D'utilisation Et D'entretien page 68

Standard dual row adjustment (35 - 39)
NOTICE
Adjustment is only possible if the flexible plate (A) is
positioned with respect to the drop tube (B) as shown
in the figure.
C
E
C
UN41-0550BN
Proceed as outlined below.
1) Loosen the screws (C).
2) Slide the side frames (D) and (E) along the support
until the required dual row positioning is obtained.
Position the side frames so they are both located at
the same distance from the planting unit's longitudi-
nal axis.
Optional dual row range adjustment
If you need to adjust the optional dual row ranges (see "Technical characteristics" schedule), please contact the manu-
facturer for the necessary information.
English language
ADJUSTMENT INFORMATION
The lower number (x) must be facing towards the inside
of the planting unit and the higher number (y) facing
outwards.
If this is not the case, the side frames on the planting unit
must be inverted (see "Changing the standard dual row
range").
B
D
A
y
3) Tighten the screws (C).
4) Check - and if necessary adjust - the flexible plate (see
"Adjusting the flexible plate with the ploughshare").
20
x x
y
5
B
A
Use and maintenance