Faults - Causes And Remedies - Soehnle 3720 Professional Mode D'emploi

4. FAULTS – CAUSES AND REMEDIES
If you are unable to correct the fault or if other error messages appear, please contact your
service partner.
www.soehnle-professional.com
DISPLAY
When switched on, the scales are set
automatically to zero. If the scales are
outside the specified tolerance range,
the display shows -0-.
Underload: only dashes appear at the
bottom of the display field.
Overload: only dashes appear at the
top of the display field. Maximum
weighing range is exceeded.
Part weight is too low.
Weight has gone above or below zero
setting limit.
Taring not possible with the scales
unloaded, not yet stabilised, or
overloaded.
Printing not possible in the case of
underload or overload.
kg/lb switching blocked.
REMEDY
Please check whether your
actions are correct. If
necessary, interrupt the
command sequence by
pressing the On/Off button.
Unload the platform. Remove
any dirt if present. If the scales
do not display a zero after a few
seconds, please contact your
service partner.
Switch the scales off and then
on again. The zero point is reset
automatically.
Remove part of the weighed
goods from the scales.
63