Synchronizing The Throttle Bodies - Yamaha RX10RTL Supplément Au Manuel D'atelier

SYNCHRONIZING THE THROTTLE BODIES

SYNCHRONIZING THE THROTTLE BODIES
NOTE: NOTE:
Prior to synchronizing the throttle bodies, the
valve clearance and the engine idling speed
should be properly adjusted and the ignition
timing should be checked.
1. Place the machine on a level surface.
2. Remove:
• shroud
• hood (left and right)
• headlight assembly
• headlight stay
Refer to "COWLINGS" in CHAPTER 3.
3. Install:
• vacuum gauge
(onto the synchronizing hose
Vacuum gauge
90890-03094, YU-08030
4. Install:
• headlight stay
• headlight assembly
• hood (left and right)
Refer to "COWLINGS" in CHAPTER 3.
5. Start the engine and let it warm up for sev-
eral minutes.
6. Measure:
• engine idling speed
Out of specification → Adjust.
Refer to "ENGINE IDLE SPEED ADJUST-
MENT".
Engine idling speed
1,500 ± 100 r/min
(1,400 ~ 1,600 r/min)
10
INSP
ADJ
)