Fuel Line Inspection; Cooling System - Yamaha RX10RTL Supplément Au Manuel D'atelier

FUEL LINE INSPECTION/COOLING SYSTEM

FUEL LINE INSPECTION

1. Remove:
• Top cover
Refer to "COWLINGS" in CHAPTER 3.
2. Remove:
• Intake silencer
Refer to "FUEL INJECTION" in CHAPTER 7.
3. Inspect:
• Fuel hoses
• Fuel delivery hoses
Cracks/damage → Replace.
4. Install:
• Intake silencer
Refer to "FUEL INJECTION" in CHAPTER 7.
5. Install:
• Top cover
• Refer to "COWLINGS" in CHAPTER 3.

COOLING SYSTEM

Coolant replacement
NOTE: NOTE:
The coolant should be changed at least every
season.
1. Place the machine on a level surface.
2. Remove:
• Top cover
Refer to "COWLINGS" in CHAPTER 3.
3. Remove:
• Intake silencer
Refer to "FUEL INJECTION" in CHAPTER 7.
4. Remove:
• Coolant filler cap
WARNING
Do not remove the coolant filler cap
when the engine is hot. Pressurized scald-
ing hot fluid and steam may be blown out,
which could cause serious injury. When the
engine has cooled, place a thick rag or a
towel over the coolant filler cap.
Slowly turn the cap counterclockwise until
it stop. This allows any residual pressure to
escape. When the hissing sound has
stopped, press down on the cap while turn-
ing it counterclockwise to remove it.
5
INSP
ADJ