Yamaha RX10RTL Supplément Au Manuel D'atelier page 160

Fault code No. 35
Used diagnostic code No. 32 (ignition coil #3)
Order Inspection operation item and probable
cause
1 Connected condition of connector
Inspect the coupler for any pins that
may have pulled out.
Check the locking condition of the
coupler.
2 Open or short circuit in lead wire.
3 Defective ignition coil (test the primary
and secondary coils for continuity).
Fault code No. 36
Used diagnostic code No. 33 (ignition coil #4)
Order Inspection operation item and probable
cause
1 Connected state of connector
Inspect the coupler for any pins that
may have pulled out.
Check the locking condition of the
coupler.
2 Open or short circuit in lead wire.
3 Defective ignition coil (test the primary
and secondary coils for continuity).
FUEL INJECTION SYSTEM
Symptom Malfunction detected in the primary lead of the ignition coil (#3).
Operation item and countermeasure
If there is a malfunction, repair it and connect it
securely.
Ignition coil primary side coupler – Orange/
Green
Main wiring harness ECU coupler
Repair or replace if there is an open or short circuit.
Between ignition coil coupler (#3) and ECU
coupler/main harness
Orange/Green – Orange/Green
Red/White – Red/White
Execute the diagnostic mode (Code No.32).
Replace if defective.
Refer to "IGNITION SYSTEM" in CHAPTER 8.
Symptom Malfunction detected in the primary lead of the ignition coil (#4).
Operation item and countermeasure
If there is a malfunction, repair it and connect it
securely.
Ignition coil primary side coupler – Green
Main wiring harness ECU coupler
Repair or replace if there is an open or short circuit.
Between ignition coil coupler (#4) and ECU
coupler/main harness
Green – Green
Red/White – Red/White
Execute the diagnostic mode (Code No.33).
Replace if defective.
Refer to "IGNITION SYSTEM" in CHAPTER 8.
79
FI
Reinstatement
method
Reinstated by
starting the
engine and
operating it at
idle.
Reinstatement
method
Reinstated by
starting the
engine and
operating it at
idle.