Hookup Instructions - Gtec SATURN Serie Manuel D'installation Et D'utilisation

H
OOKUP INSTRUCTIONS
Follow the instructions below in order:
 open the door
 Depending on model: remove the terminal/bar cover (see "Switches view")
125KVA: to remove the bar cover, first remove the handles of the
SWIN, SWOUT, SWBYP and SWMB switches by undoing their screws
as shown in the image.
 connect the protective conductor (ground cable) to the PE marked screw.
 Depending on model: connect the input, bypass (if present), output and battery cables to the terminals/bars; follow the
hookup indications in "UPS connections view". Connect the N BATT, N INPUT, N BYPASS (if present) and N OUTPUT
cables to the neutral bar.
Note: PE M6 screw, N M8 screw
The input and bypass Neutral must always be connected.
The input and bypass lines must be connected to the same potential as of the Neutral.
 Once you have completed the installation and checked the connections (see "First power on and initial settings"), restore
the terminal/bar cover.
125kVA: Restore the switch handles.
 Close the door.
Once installation operations have been completed and connections verified (see paragraph "First start-up and initial settings"),
restore the terminal cover panel and close the door.
Example image (purely illustrative)
- 75 -