Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
q
Cleaning brush.
w
Pipe of pellets fall.
5.16.
Lubrication of the brass tips of the endless shaft's upper and lower parts with lubricant oil; a small quantity is
enough for all the season. This operation is ONLY recommended in case of noisy.
You get access to the lower tip from inside the hopper, you will see it clearly after removing all pellets.
In order to reach the upper tip, you have to dismantle the endless screw from the back side of the boiler; this
shall be necessary only in case of noise as it has been lubricated at manufacturing, with a high quality
lubricant sufficient for many years.
q
Reducing motor of endless.
w
Brass fitting and lubrication point.
IMPORTANT: After cleaning or fixing, make sure the boiler operates correctly. Once you turn the boiler off or
during the seasons when you do not use it, disconnect the boiler to avoid electronic damages.
It consists in controlling the combustion air inlet and gas outlet; make sure nothing prevents normal
circulation (e.g. bird nests).
In addition, it is recommended to clean the back side of the boiler that you reach through the back grid or
lateral doors, in order to take eventual dust away that might have stacked during summer time.
6.
PROBLEMS AND RECOMMENDATIONS.
6.1.
Do not turn the boiler on and off successively because this might damage the electronical components and
motors ~230/240V - 50Hz.
6.2.
Do not touch the boiler while your hands are wet. Though the boiler is equipped with ground plug, it
remains an electric machine that could cause electric discharge if handled incorrectly. A qualified technician
only shall resolve the eventual problems.
6.3.
Do not remove any screw of the zones exposed to high temperature before they have been lubricated
properly with lubrication oil.
CHECKING AT BEGINNING OF SEASON.
WHAT NOT TO DO.
49
Drawing 31
Drawing 32
Publicité
Table des Matières
