Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
w
Ash box.
e
Cleaning outlet.
In Super Insert models, the cleaning outlets are in the rear and on the right side of the boiler. The cleaning
procedure is the same as in Hidrocopper models.
e
Cleaning outlet.
It is recommendable to calculate the frequency with which you clean the outlet cleaning considering the
hours of operation, thus avoiding ash saturation.
Once you clean the walls of the boiler, you must be sure that the cleaning outlet is securely closed, since the
proper operation of the boiler depends on this cleaning.
5.9.
Cleaning of the gas outlet circuit. Always with the boiler disconnected. (Very important).
With the boiler disconnected, open the side doors (except in Insert models) which give you Access to the
cleaning hatches- you must open the side outlets and introduce a wire brush and move it repeatedly in every
way to get release all ashes adhered to the gas chamber walls. For an optimum cleaning of the extractor
collector is advisable to remove the extractor, this will give you full Access to the whole area for a better
cleaning. Once you have removed the extractor, clean it with a dry brush, paying particular attention to the
turbine and the casing.
47
Drawing 27
Drawing 28
Publicité
Table des Matières
