Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
PLEASE BEWARE THAT...
Your boiler is designed to burn wooden pellets.
In order to prevent the risk of accident, a correct installation must be done following the instructions of this
manual. Your ECOFOREST distributor will be available to help you and provide you information related to codes,
assembly and installation norms in your area.
The gas outlet system works is a vacuum system (no air within the burn pot), for this reason, it is necessary
for this system to be hermetically sealed. A regular check may be required to ensure a correct gas outlet.
It is recommended to clean the gas outlet system twice a year or after having used 500kg of pellets. To
prevent defects in operation, it is required to install the gas outlet in a vertical position using a "T" and have at
least 1,5m of the flex vertically, never more than 1m. horizontally (see point 4).
The ground plug shall be connected to ~230/240V - 50Hz. Please make sure the power cable does not remain
under the boiler nor close to hot areas of the boilers and it is not in contact with sharp areas that could damage it.
When the boiler is installed in a mobile-home, the ground plug shall be connected to a metallic part on the
ground and perfectly adjusted. Make sure the structure of the house supports the boiler's weight.
Make sure the gas outlet flex going through the roof is not in contact with any flammable material to avoid
any risk of fire.
AS ECOFOREST DO NOT HAVE DIRECT CONTROL ON THE INSTALLATION OF YOUR BOILER,
ECOFOREST DO NOT GUARANTEE IT AND DO NOT BEAR THE RESPONSIBILITY OF ANY DAMAGE THAT
COULD RESULT FROM A BAD USE OR A BAD INSTALLATION.
WE CAREFULLY RECOMMEND THE HEAT CALCULATION TO BE MADE BY A QUALIFIED HEATING
ENGINEER.
2.
ADVICE AND RECOMMENDATIONS.
2.1.
Place the boiler on a stable area to avoid unexpected shifts.
2.2.
Never use petrol, fuel for lanterns, kerosene nor any similar liquid. Keep this kind of fuel away from your
boiler.
2.3.
Do not try to turn on your boiler if some glass is broken.
2.4.
Make sure the glass door of the fireplace is well closed while the boiler is in operation; also check the ashtray
and cleaning trap are there.
2.5.
Do not overload the boiler; continuous heating efforts might cause premature aging and damage paint (it is
recommended not to exceed 250°C for gas outlet temperature).
2.6.
Do not use the boiler as a burner.
2.7.
The boiler shall always be connected to a ground plug and an AC stable supply of ~230/240V - 50Hz and sine
wave.
2.8.
The boiler must be switched on at least every 15 days to avoid possible condensation in areas under fire.
2.9.
It is recommended to mount a pressure gauge in the water installation, to compare the pressure of the
circuit with which the boiler indicates.
3.
FUEL (PELLETS) QUALITY.
Your boiler works with wooden pellets. Many types of pellets are sold on the market, with very different
quality levels. For this reason, it is very important to choose pellets free from dirt, with no excessive level of damp or
additives that compact sawdust.
The boiler output may vary depending on the type of pellets you use.
ECOFOREST do not have any control on the quality of the pellets you use. For this reason, ECOFOREST cannot
guarantee the full output of your boiler nor the eventual premature aging or eventual damage of the gas outlet. It is
recommended to use ECOFOREST pellets which are approved as per European standard DIN 51731 and
distinguished by the logo of ECOFOREST printed on the 15kg bags.
33
Publicité
Table des Matières
