Technical Data; Machine Dimensions; Working Range - Corghi EM 9550 Plus Laserline Manuel D'utilisation

rim spokes.
- "Split Weight" programme (motorcycle pro-
grammes) for dividing the weight into two
equal weights to be placed on either side of
the spoke.
- "Flash OPT" programme for rapid optimisation
of operating noise reduction.
- "FSP" (Fast Selection Program) programme
for the automatic selection of the balancing
programme.
- General utility programmes:
• calibration;
• service;
• diagnostics.
- Three separate working environments, allowing
three different operators to work in parallel with
no need to set the data again.
- RPA, automatic wheel positioning in the po-
sition where the balancing weight has to be
applied.
- Wheel spin counter (partial and total number);
- Possibility to select the position for applying
the adhesive weight:
- Vertical plane in the lower part of the wheel
(H6) using the LASER line
- Vertical plane in the upper part of the wheel
(H12).
- CLIP: using the weight-holder terminal in the
ALUP balancing programmes (in all the other
H12 balancing programmes)
50
Power supply voltage ......1Ph 100-230V 50-60Hz
Overall power ...............................................400W
Rated current ..............................................1.7-4A
Balancing speed............................75 - 85 - 98rpm
Maximum unbalance value calculated ........999g
Average wheel spin time (with 5"x14" wheel)......5.5s
Shaft diameter ..............................................40mm
Operating environment temperature, .......5 to 40°C.
Weight of electrical/electronic
components, Std: ............................................. 5kg
Weight of the electrical/electronic components
with the automatic wheel clamping system: 7kg
depth with guard closed .......................1378 mm
depth with guard open.............................894 mm
width with guard ......................................1453 mm
height with guard closed .......................1600 mm
height with guard open...........................1884 mm
automatic rim width........................from 1.5" to 20"
manual rim width..........................from 1.5" to 24"
automatic rim diameter.....................from 1" to 28"
rim diameter can be set manually....from 1" to 35"
automatic max. wheel/machine distance ...........
................................................from 1 to 350 mm
max. wheel/machine distance can be set manually
EM 9550 Plus - EM 9550 C Plus - Operator's manual

TECHNICAL DATA

Machine dimensions

Working range

12