Corghi EM 9550 Plus Laserline Manuel D'utilisation page 45

C
A
EM 9550 Plus - EM 9550 C Plus - Operator's manual
Wheel guard and related
support mounting procedure
- Install the bush (A, fig. 5) on the pivot (B, fig.
5). While doing this, ensure that the groove on
the pivot is aligned with the pin in the bush;
4a
- Block the bush on the pin using the M12 screw
supplied with the machine.
- Insert the metal tube (D, fig.8) into the two
plastic guard front holes (C, fig.8);
- Fasten the guard to the rear of the pipe, snap
fitting into the relative seat (E, fig. 8);
- Lock the guard by tightening the screw F (fig.8).
4b
B
4c
B A
E
F
5
UK
C
8
D
45