Sticker - Truma DuoControl Mode D'emploi

The DuoControl is intended for installation in the gas cylinder
box of the caravan or motor home.
When it is being used outdoors, the DuoControl must
be protected from the elements and dripping water
with a protection hood.
Choose a suitable position for the DuoControl, in particular:
– Type plate legible,
– Status indicator recognisable,
– Avoid damage during cylinder replacement,
– Make it difficult for gas in the liquid phase to penetrate,
– Allow enough room to retrofit the Truma remote indicator,
– Route high-pressure hoses without tension.
– If the gas cylinder valves are more than one metre apart,
the additional kit (part no. 50020-61100) may be used.
Figure 6
– Fasten to a stable wall / ceiling with 4 screws.
Ensure that it is firmly attached.
– Screw high-pressure hoses to the gas filter / DuoControl in-
lets, using elbow unions (part. no. 50020-56000) if necessary.
> 100 cm
– When installation is complete, have the entire gas system
inspected by a specialist technician to check for leaks and
correct installation. Check the hose connections at the
DuoControl inlet for leaks (e.g. using a leak-finder spray in
accordance with DIN EN 14291).
This test does not replace the regularly scheduled gas
check!
– All functions must then be tested in accordance with the
operating instructions.
– The operating instructions must be given to the operator.

Sticker

In vehicles from construction date 01/2007, the gas cylinders
must be closed while driving when using the DuoControl gas
pressure regulation system.
– The supplied stickers must be applied in the cylinder box
and close to the control panel for the liquid gas heater.
21