Publicité
For connecting the aileron and landing flap servos to the receiver you will need four
suppressor filters, Order No. 1040, or one folding ferrite ring, Order No. 98516.1 with
four extension leads, Order No. 3935.18.
The two aileron servo leads should be extended using extension leads, Order No.
3935.35 ; for the two landing flap servos you will need extension leads,
Order No. .3935.11
Foam padding for the receiver and receiver battery is included in the kit.
Standard-size servos can be used in this model.
Adhesives
Fast-setting epoxy resin, e.g. UHU plus schnellfest, Order No. 962
Slow-setting epoxy resin, e.g. UHU plus endfest 300, Order No. 950.43
White glue, e.g. UHU Holzleim express, Order No. 958.60
Cellulose cement, e.g. UHU hart, Order No. 534.35
Cyano-acrylate glue ("cyano"), e.g. Order No. 5821
Cyano-acrylate glue ("cyano"), e.g. Order No. 5822
Thread-lock fluid, e.g. Order No. 952
Accessories for flying the model (not included)
Synthetic oil based glow fuel, to suit motor
Fuel filter, e.g. Order No. 1650.1
Fuel tubing, e.g. Order No. 1643
Manual fuel pump, e.g. Order No. 1610 or 6870
Glowplug energizer battery and clip, e.g. Order No. 3248
Electric starter, e.g. Order No. 1628
Starter battery, e.g. Order No. 2592
Tools required (not included)
Various (cross-point) screwdrivers, pointed-nose pliers, flat-nose pliers, side-cutters,
balsa knife or razor blade, set of twist drills, universal glowplug spanner, pencil, felt-
tip pen, fine-tip soldering iron, Z-bend pliers, Order No. 5732
Assembling the PIAGGIO P 149 D
Wing and undercarriage
Don't start building the model until you have read right through the building
instructions and are familiar with all the model's components and stages of
construction. If you are not satisfied with any part, inform your supplier before you
start work on the aircraft.
Draw a pencil-mark on each of the aileron hinges to mark the centreline.
The hinges can now be slid into the control surfaces as far as the pencil marks, and
glued in place with a few drops of thin cyano. The best method is to push the hinges
into the slots in the control surfaces to a depth of about 1 mm, apply drops of cyano
to both sides of each hinge, then push them in as far as the pencil line.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
05/2009
51
Publicité
