Publicité
Specification
Wingspan approx.
Fuselage length excl. spinner approx.
Wing area approx.
Tailplane area approx.
Total surface area approx.
All-up weight according to fittings approx.
Longitudinal dihedral
Centre of Gravity, measured at
the root leading edge, approx.
Caution: this model is not a toy!
If you are a beginner to this type of powered model, please ask an experienced model
flyer for help and support. If you attempt to operate the model without knowing what you
are doing, you could easily injure yourself or somebody else. Please keep your safety and
well-being in mind at all times.
Important: before you start construction
Even if you have already built a large number of RC models please read right through
these instructions and check that all the kit components are actually present. We have
taken great trouble to keep construction as simple as possible, without making any
compromises in the area of safety.
Note regarding the film covering
Minor creases or bubbles may develop in the film covering due to major fluctuations in
weather conditions (temperature, humidity etc.); in rare cases you may even find a slight
warp in a component. These minor faults are in the nature of film-covered built-up wooden
structures, and can easily be corrected using a heat gun, as commonly used for modelling.
Creases:
Blow warm air over the area and rub down with a soft cloth.
Wing warp:
Hold the panel twisted gently in the opposite direction to the warp, and
apply warm air to remove the creases from the covering.
Caution! do not heat the film more than is absolutely necessary. If the air or the iron is too
hot, the film may melt and holes may be formed.
This model is highly pre-fabricated and can be built in a very short time. However, the
work which you have to carry out is important and must be done carefully. The model will
only be strong and fly well if you complete your tasks competently - so please work slowly
and accurately.
When self-tapping screws have to be screwed into wood, apply a little white glue to
prevent them shaking loose: just squirt white glue into the hole and fit the screw.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
1800 mm
1450 mm
51.3 dm²
11.2 dm²
62.5 dm²
5400 g
0 - 0.5 degrees
140 mm
43
05/2009
Publicité
