Table des Matières
Publicité
Italiano
Potenza massima di
Distanza di separazione in base alla frequenza del trasmettitore m
trasmissione
indicata per il
150 kHz a 80 MHz
trasmettitore W
d
1
2 .
P
0.01
0.12
0.1
0.38
1
1.2
10
3.8
100
12
Per i trasmettitori la cui potenza massima di emissione non viene indicata nell'elenco, la
distanza di separazione d consigliata in metri (m) può essere stimata utilizzando l'equazione
applicabile alla frequenza del trasmettitore, dove P rappresenta l'indice di potenza di
trasmissione massima del trasmettitore in Watt (W) in base al fabbricante del trasmettitore.
Nota 1: A 80 MHz e 800 MHz, viene applicata la distanza di separazione per l'intervallo di
frequenza maggiore.
Nota 2:Queste regole non vengono applicate in tutte le situazioni. Sulla propagazione
elettromagnetica influisce l'assorbimento e la riflessione di strutture, oggetti e
persone.
80 MHz a 800 MHz
Da 800 MHz a 2,5 GHz
d
1
2 .
P
d
2
3 .
P
0.12
0.23
0.38
0.73
1.2
2.3
3.8
7.3
12
23
160
English
IMPORTANT SAFEGUARDS – PLEASE MAKE THIS
PRECAUTIONS LIST AVAILABLE TO ALL USERS and
PROVIDERS
READ ALL INSTRUCTIONS BEFORE USING THIS SYSTEM
WARNING –
1.
THIS DEVICE IS NOT INTENDED FOR LIFE SUPPORT. It may stop operating due to power
interruption but no hazards to patient.
2.
If oxygen is used with the device, the oxygen flow must be turned off when the device is not in
use.
Explanation of the Warning: When the device is not in operation and the oxygen flow is left on,
oxygen delivered into the tubing may accumulate within the device's enclosure and create a risk
of fire.
3.
Oxygen supports combustion. Oxygen should not be used while smoking or in the presence of an
open flame.
4.
Always ensured the device is generating airflow before the oxygen supply is turned. Always turn
off the oxygen supply before stopping the airflow from the device.
5.
This device should not be used in the vicinity of a flammable anesthetic mixture in combination
with oxygen or air and nitrous oxide.
6.
The airflow for breathing generated by this device may be as much as 7°C (12.6° F) higher than
the room temperature. This device should not be used if the room temperature is warmer than
35°C (95°F) to prevent the airflow temperature from exceeding 40° C (104° F) and causing
irritation to your airway.
7.
If this device overheats, it will stop operating and show "Error 002" on the display. After cooling
down to proper temperature, the device can restart again.
8.
This machine should be used only with masks (and connectors) recommended by the
manufacturer, or by your physician or respiratory therapist. A mask should not be used unless the
CPAP machine is turned on and operating properly. The vent holes associated with the mask
should never be blocked for proper exhaling purpose. If the vent hole is blocked, the CPAP
machine will stop and show message "Error 002", after cooling down, please re-connect the
power cord to reset the machine.
9.
At low CPAP pressure, some exhaled gas may remain in the mask and be re-breathed.
1
Publicité
Table des Matières
